__________________________________________
Ranga Nathan / CSG
Systems Programmer - Specialist; Technical Services;
BAX Global Inc. Irvine-California
Tel: 714-442-7591 Fax: 714-442-2840
Michael MacIsaac <[EMAIL PROTECTED]>
Sent by: Linux on 390 Port <[EMAIL PROTECTED]>
11/17/2004 10:24 AM
Please respond to Linux on 390 Port
To: [EMAIL PROTECTED]
cc:
Subject: Re: z/VM IPL questions - Shutdown reipl
Ranga,
> When I "shutdown reipl" from a 3270 remote terminal, the IFL LPAR goes
inactive after the shutdown.
I've seen this too and it is annoying.
Do you see a DISABLED WAIT error message in the Hardware Messages? If you
drill down into the Details, do you see the last 4 digits of the PSW are
"1010"? This is the wait state for "I can't find a console". I may be
wrong on some of these assumptions but I believe the key is to leave the
Integrated 3270 console up on the HMC. Then z/VM will shutdown AND reipl
cleanly without intervention in about 2-3 minutes. It would be nice if you
could "SHUTDOWN REIPL" VM without a console being necessary.
Yes, it is a little annoying. Other sysprogs complain that I am leaving
the HMC logged on. Yes, I could not logoff without also closing the 3270
integrated console!
"Mike MacIsaac" <[EMAIL PROTECTED]> (845) 433-7061
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
