Try running zipl. >>> [EMAIL PROTECTED] 12/06/04 04:50PM >>> While IPL'ed from an install tape, I've run through the install of the required applications from the 'A' series of SLACK390, and completed the setup and configuration script. When I halt my system and attempt to IPL/boot from the volume that has the /boot directory on it, my Linux partition goes into a disabled wait state. I think that the problem is that my volume is not a valid IPL device. I've read the IBM Redbook Linux for S/390 (SG24-4987), which has you use the SILO command to write the IPL record onto the volume. I can't find anything similar to this in the Slack390 product. Has anyone seen this or know a way around this?
Thanks, Richard ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
