Did you really put single quotes around the parms, and include a line feed, or is that just the way the prompt looks on the 3215 console? I don't see what you entered in response, so I can't comment on that.
Check to make sure the NIC is defined, and coupled to the VSWITCH. #cp q nic details #cp q lan details Also, someone at SUSE needs to update the script. The data channel absolutely does _not_ have to be "the Read Channel address plus 2." Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Tom Driscoll Sent: Wednesday, April 20, 2005 11:35 AM To: [email protected] Subject: qeth initialization failure trying to install SLES9 I am trying to install SLES9 (31 bit) under z/VM 5.1 and am getting the error below. Address 700-702 points to a VSWITCH. Has anyone seen this before? Are these codes documented anywhere? Thanks. Messages: Loading qeth... qdio: loading QDIO base support version 2 ($Revision: 1.79.2.1 $/$Revision: 1.57 $/$Revision: 1.23 $) qeth: loading qeth S/390 OSA-Express driver ($Revision: 1.77.2.20 $/$Revision: 1 .98.2.11 $/$Revision: 1.27.2.5 $/$Revision: 1.8.2.2 $/$Revision: 1.7.2.1 $/$Revi sion: 1.5.2.4 $/$Revision: 1.19.2.7 $ :IPv6 :VLAN) Detecting available channels ... done 3 OSA Express, Gigabit Ethernet or High Speed Token Ring Channels were detected. First OSA Express, Gigabit Ethernet or High Speed Token Ring Channels that were detected: Device Addresses CHPID(s) 0700 01 0701 01 0702 01 Format for OSA Express configuration: Read Channel,Write Channel,Data Channel The Read Channel must be an even device address, The Write Channel must be the Read Channel address plus 1, The Data Channel must be the Read Channel address plus 2. Possible configuration: read: 0x0700, write: 0x0701, data: 0x0702 Enter the device addresses for the qeth module, e.g. '0.0.0700,0.0.0701,0.0.0702 ' Device 0.0.0700 configured qeth: received an IDX TERMINATE with cause code 0x4e qeth: Initialization in hardsetup failed! rc=-5 eth0: error fetching interface information: Device not found eth0 not available, check device addresses/cards. Do you want to retry the qeth-setup (Yes/No) ? ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
