He already gave you one: load the driver manually, and see what, if any, error/warning messages come out. Next, try searching the /sys hierarchy for the device number(s) of the interface. You'll need to read the Linux 2.6 Device Drivers and Installation Commands manuals to understand what you need to do with what you find.
I one wrote myself a little cheat sheet for doing this for QDIO/QETH devices. It will apply in a similar, but not exact, manner for LCS: modprobe qeth echo 0.0.0f00,0.0.0f01,0.0.0f02 > /sys/bus/ccwgroup/drivers/qeth/group echo 1 > /sys/bus/ccwgroup/drivers/qeth/0.0.0f00/online ifconfig eth0 Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Carlos A Bodra Sent: Thursday, July 28, 2005 11:21 AM To: [email protected] Subject: Re: LCS under linux 2.6.x David, Can you give me some hints about how to configure LCS under debian 2.6? Carlos Alberto Bodra S/390 System Programmer Sao Paulo - Brazil -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of David Boyes Sent: Thursday, July 28, 2005 11:23 AM To: [email protected] Subject: Re: LCS under linux 2.6.x > > I'm trying to setup a new Debian Kernel 2.6.x using LCS device, but I > was unable to make it work. If I display interface, in place of LCS0 > (as before in Kernel 2.4.x) now I see SIT0. How to define this, so I > can access network. Sit0 is the IPv6-over-IPv4 tunneling driver. If you are not getting a LCS device created, have you tried loading the LCS driver manually? If so, what are the messages? Have you considered a support agreement? There are several organizations that provide Debian support for issues like these. -- db ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
