Hi Mark,
yes, here's what I see from those commands
Thanks for helping out here
01: CP Q NIC DETAILS
01: Adapter 5000 Type: QDIO Name: GUESTLAN Devices: 3
01: Port 0 MAC: 02-00-00-00-00-04 LAN: SYSTEM GUESTLAN MFS: 8192
01: RX Packets: 21 Discarded: 0 Errors: 0
01: TX Packets: 20 Discarded: 0 Errors: 0
01: RX Bytes: 6574 TX Bytes: 1314
01: Connection Name: HALLOLE State: Session Established
01: Device: 5000 Unit: 000 Role: CTL-READ
01: Device: 5001 Unit: 001 Role: CTL-WRITE
01: Device: 5002 Unit: 002 Role: DATA
01: VLAN: ANY Assigned by user
01: Unicast IP Addresses:
01: 155.180.147.41 Mask: 255.255.255.0
01: FE80::200:0:100:4/64
01: Multicast IP Addresses:
01: 224.0.0.1 MAC: 01-00-5E-00-00-01
01: 224.0.0.251 MAC: 01-00-5E-00-00-FB
01: 224.0.1.22 MAC: 01-00-5E-00-01-16
01: 239.255.255.253 MAC: 01-00-5E-7F-FF-FD
01: FF02::1 MAC: 33-33-00-00-00-01
01: FF02::1:FF00:4 MAC: 33-33-FF-00-00-04
01:
01: CP Q LAN DETAILS
01: LAN SYSTEM GUESTLAN Type: QDIO Active: 5 MAXCONN: INFINITE
01: PERSISTENT UNRESTRICTED MFS: 8192 ACCOUNTING: OFF
01: Adapter Owner: TCPIP NIC: 5000 Name: GUESTLAN
01: Adapter Owner: ZLIN01 NIC: 5000 Name: GUESTLAN
01: Adapter Owner: ZLIN02 NIC: 5000 Name: GUESTLAN
01: Adapter Owner: ZLIN04 NIC: 5000 Name: GUESTLAN
01: Adapter Owner: ZLIN06 NIC: 5000 Name: GUESTLAN
#ifconfig -a
eth0 Link encap:Ethernet HWaddr 02:00:00:00:00:04
inet addr:155.180.147.41 Bcast:155.180.147.47
Mask:255.255.255.240
inet6 addr: fe80::200:0:100:4/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1482 Metric:1
RX packets:23 errors:0 dropped:0 overruns:0 frame:0
TX packets:31 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6926 (6.7 Kb) TX bytes:3076 (3.0 Kb)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:202 (202.0 b) TX bytes:202 (202.0 b)
sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
#route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
155.180.147.32 0.0.0.0 255.255.255.240 U 0 0 0
eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0
eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 155.180.147.33 0.0.0.0 UG 0 0 0
eth0
# lsmod
lsmod
Module Size Used by
sg 51752 0
st 53540 0
sd_mod 32004 0
sr_mod 27688 0
scsi_mod 163144 4 sg,st,sd_mod,sr_mod
cdrom 48672 1 sr_mod
qeth 190284 0
qdio 58672 2 qeth
ipv6 332004 76 qeth
ccwgroup 17408 1 qeth
dm_mod 77640 0
dasd_fba_mod 19456 1
dasd_eckd_mod 69632 4
dasd_mod 79168 7 dasd_fba_mod,dasd_eckd_mod
ext3 153440 1
jbd 92964 1 ext3
William 'Doug' Carroll
Mainframe Systems Engineer II
Global Technology Infrastructure
(614) 213-4954 Office
(877) 899-1697 Pager
(614) 244-9897 Fax
http://www.bankone.com
"Post, Mark K"
<[EMAIL PROTECTED] To:
[email protected]
m> cc:
Sent by: Linux on Subject: Re: Can't Access YAST
to complete install
390 Port
<[EMAIL PROTECTED]
ist.edu>
08/15/2005 11:11
PM
Please respond to
Linux on 390 Port
Ok, if you've figured out how to be able to issue ping commands, then
the following commands will be of interest:
#cp q nic details
#cp q lan details
ifconfig -a
route -n
lsmod
Mark Post
-----Original Message-----
From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of
Doug Carroll
Sent: Monday, August 15, 2005 5:17 PM
To: [email protected]
Subject: Re: Can't Access YAST to complete install
Sorry, I'm not seeing post on my topic at all, just checked the
archives and saw some replies.
for some of the questions,
the SLES9 host is on the same subnet as my SLES8 hosts and I can not
ping in either direction. SLES8 and SLES8 are both on the same guestlan.
i.e. SLES8 can not ping SLES9 host and visa-versa I can not ping the
Gateway either from the SLES9 host I can ping the SLES9s own IP from
SLES9 the /28 is the correct subnet for the host
i have tried re-ipling the SLES9 server and it goes through skipping the
customization steps it is still unreachable
William 'Doug' Carroll
Mainframe Systems Engineer II
Global Technology Infrastructure
(614) 213-4954 Office
(877) 899-1697 Pager
(614) 244-9897 Fax
http://www.bankone.com
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions, send
email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
