The setup looks good from what I can see. _Something_ is going in and out of that interface (about 20 packets worth). Is the TCPIP Service Virtual Machine the default gateway at 155.180.147.33? Can you ping that?
What are the IP addresses of the other systems on the GuestLAN? Does "arp -an" show anything after a "ping -c 3 -b 155.180.147.47" ? Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Doug Carroll Sent: Tuesday, August 16, 2005 9:57 AM To: [email protected] Subject: Re: Can't Access YAST to complete install Hi Mark, yes, here's what I see from those commands Thanks for helping out here 01: CP Q NIC DETAILS 01: Adapter 5000 Type: QDIO Name: GUESTLAN Devices: 3 01: Port 0 MAC: 02-00-00-00-00-04 LAN: SYSTEM GUESTLAN MFS: 8192 01: RX Packets: 21 Discarded: 0 Errors: 0 01: TX Packets: 20 Discarded: 0 Errors: 0 01: RX Bytes: 6574 TX Bytes: 1314 01: Connection Name: HALLOLE State: Session Established 01: Device: 5000 Unit: 000 Role: CTL-READ 01: Device: 5001 Unit: 001 Role: CTL-WRITE 01: Device: 5002 Unit: 002 Role: DATA 01: VLAN: ANY Assigned by user 01: Unicast IP Addresses: 01: 155.180.147.41 Mask: 255.255.255.0 01: FE80::200:0:100:4/64 01: Multicast IP Addresses: 01: 224.0.0.1 MAC: 01-00-5E-00-00-01 01: 224.0.0.251 MAC: 01-00-5E-00-00-FB 01: 224.0.1.22 MAC: 01-00-5E-00-01-16 01: 239.255.255.253 MAC: 01-00-5E-7F-FF-FD 01: FF02::1 MAC: 33-33-00-00-00-01 01: FF02::1:FF00:4 MAC: 33-33-FF-00-00-04 01: 01: CP Q LAN DETAILS 01: LAN SYSTEM GUESTLAN Type: QDIO Active: 5 MAXCONN: INFINITE 01: PERSISTENT UNRESTRICTED MFS: 8192 ACCOUNTING: OFF 01: Adapter Owner: TCPIP NIC: 5000 Name: GUESTLAN 01: Adapter Owner: ZLIN01 NIC: 5000 Name: GUESTLAN 01: Adapter Owner: ZLIN02 NIC: 5000 Name: GUESTLAN 01: Adapter Owner: ZLIN04 NIC: 5000 Name: GUESTLAN 01: Adapter Owner: ZLIN06 NIC: 5000 Name: GUESTLAN #ifconfig -a eth0 Link encap:Ethernet HWaddr 02:00:00:00:00:04 inet addr:155.180.147.41 Bcast:155.180.147.47 Mask:255.255.255.240 inet6 addr: fe80::200:0:100:4/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1482 Metric:1 RX packets:23 errors:0 dropped:0 overruns:0 frame:0 TX packets:31 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:6926 (6.7 Kb) TX bytes:3076 (3.0 Kb) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:4 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:202 (202.0 b) TX bytes:202 (202.0 b) sit0 Link encap:IPv6-in-IPv4 NOARP MTU:1480 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) #route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 155.180.147.32 0.0.0.0 255.255.255.240 U 0 0 0 eth0 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 0.0.0.0 155.180.147.33 0.0.0.0 UG 0 0 0 eth0 # lsmod lsmod Module Size Used by sg 51752 0 st 53540 0 sd_mod 32004 0 sr_mod 27688 0 scsi_mod 163144 4 sg,st,sd_mod,sr_mod cdrom 48672 1 sr_mod qeth 190284 0 qdio 58672 2 qeth ipv6 332004 76 qeth ccwgroup 17408 1 qeth dm_mod 77640 0 dasd_fba_mod 19456 1 dasd_eckd_mod 69632 4 dasd_mod 79168 7 dasd_fba_mod,dasd_eckd_mod ext3 153440 1 jbd 92964 1 ext3 William 'Doug' Carroll Mainframe Systems Engineer II Global Technology Infrastructure (614) 213-4954 Office (877) 899-1697 Pager (614) 244-9897 Fax http://www.bankone.com "Post, Mark K" <[EMAIL PROTECTED] To: [email protected] m> cc: Sent by: Linux on Subject: Re: Can't Access YAST to complete install 390 Port <[EMAIL PROTECTED] ist.edu> 08/15/2005 11:11 PM Please respond to Linux on 390 Port Ok, if you've figured out how to be able to issue ping commands, then the following commands will be of interest: #cp q nic details #cp q lan details ifconfig -a route -n lsmod Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Doug Carroll Sent: Monday, August 15, 2005 5:17 PM To: [email protected] Subject: Re: Can't Access YAST to complete install Sorry, I'm not seeing post on my topic at all, just checked the archives and saw some replies. for some of the questions, the SLES9 host is on the same subnet as my SLES8 hosts and I can not ping in either direction. SLES8 and SLES8 are both on the same guestlan. i.e. SLES8 can not ping SLES9 host and visa-versa I can not ping the Gateway either from the SLES9 host I can ping the SLES9s own IP from SLES9 the /28 is the correct subnet for the host i have tried re-ipling the SLES9 server and it goes through skipping the customization steps it is still unreachable William 'Doug' Carroll Mainframe Systems Engineer II Global Technology Infrastructure (614) 213-4954 Office (877) 899-1697 Pager (614) 244-9897 Fax http://www.bankone.com ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
