Okay, I had gone through YaST and looked at the interface. What was to be changed was not readily apparent, which is why I asked. So I guess I could modify that line, before I shutdown linux, and then once I restart linux it would be ready.
On Wed, Jan 21, 2009 at 4:10 PM, Mark Post <[email protected]> wrote: > >>> On 1/21/2009 at 2:51 PM, Mark Pace <[email protected]> wrote: > > So there is nothing to change within Linux to say that it is a nic on > layer > > 2 vs layer 3? I could take down my linux guest, then do the z/VM steps > and > > autolog my Linux guest and off I go? > > No, look again: > Back to Linux: > - Modify the definition for the NIC to be Layer 2 > - Bring the interface back online > - Bring the interface back up > > That first step could be done via YaST, or by directly editing the > /etc/sysconfig/hardware/hwcfg-qeth-bus-ccw-0.0.???? file to add > QETH_LAYER2_SUPPORT='1' > to it. > > > Mark Post > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO LINUX-390 or > visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > -- Mark Pace Mainline Information Systems 1700 Summit Lake Drive Tallahassee, FL. 32317 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
