I cross posted this to IBMVM and Linux on S390.
Noticing a pause during the installation of SLES10 SP2 to a guest
configured with a VSWITCH
with VLANs. I have layer2 support set in the parm file and after IPLing
from the reader, the guest
is stuck at the MAC address prompt. Hitting the enter key moves the guest
to the name server
prompt but that is set also in the parm file. Is this normal??
SCSI subsystem initialized
NET: Registered protocol family 17
loop: loaded (max 8 devices)
Starting hardware detection...
Searching
for
info file...
qdio: loading QDIO base support version 2
qeth: loading qeth S/390 OSA-Express driver
iucv: NETIUCV driver initialized
MAC address>
We just changed the VSWITCH to add VLANs and layer2, prior to that we did
not see this
behavior with the same parm file. Here is how our VSWITCH access is
configured, should
the TCP/IP stack for VM be trunked? In the list S10SP2BD and S10SP2IT are
linux guests.
xg1dtech:~# vmcp q vswitch vswitch1 acc
VSWITCH SYSTEM VSWITCH1 Type: VSWITCH Connected: 5 Maxconn: INFINITE
PERSISTENT RESTRICTED ETHERNET Accounting: OFF
VLAN Aware Default VLAN: 0240 Default Porttype: Trunk GVRP: Enabled
Native VLAN: 0001 VLAN Counters: OFF
MAC address: 02-BD-43-00-00-01
State: Ready
IPTimeout: 5 QueueStorage: 8
Authorized userids:
SYSTEM Porttype: Trunk VLAN: 0240
S10SP2BD Porttype: Access VLAN: 0240
S10SP2IT Porttype: Access VLAN: 0240
TCPIP Porttype: Trunk VLAN: 0139 0240
Regards,
Jihad K. Kawkabani
IT Systems Engineer Consultant
Voice: 440.395.0740
Network: 575.0740
Cell: 440.465.2969
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
