Thanks Peter, We did understand that the items listed were by design but was just indication the reasons why were going to try to work around these limits.
We had looked at the VSS (and will do again thanks for the reminder) but are going to see if we can get this idea to work. Thanks again, Paul -----Original Message----- From: Linux on 390 Port [mailto:[email protected]] On Behalf Of Harder, Pieter Sent: Wednesday, May 13, 2009 2:48 PM To: [email protected] Subject: Re: channel bonding using 2 Vswitches >1. We found that when you add OSAs to a Vswitch and setup link >aggregation that the OSAs is used only on that Vswitch. That is by definition. Setting up layer2 LACP requires exclusivity for the OSA chpid. >2. When you setup port channeling in the Real Switch you must be >reading (Vswitch side) from every OSA Also by definition. An OSA not answering port channeling frames is down as far as the inquiring side is concerned. >3. This seems to be the only way we could configure to support a >real switch failure. No, it can be done for example with Cisco VSS switch pairs, where the failover of the real switch box is a function of the VSS code. Other vendors may/may not have this feature, I am no networking guy. Now to your main question: how are you going to tell the two VSWITCHes involved the VNICs form a port channel? It does not even work with one VSWITCH (I tried) as VSWITCH has no port channeling other than to real OSA's. You can define two VNICs on one guest to the same VSWITCH and put Linux bonding to them, but only one VNIC will be used. The other one is useless and does not even have a role as failover as the first one can have no hardware failure to failover from. Best regards, Pieter Harder [email protected] tel +31-73-6837133 / +31-6-47272537 Brabant Water N.V. Postbus 1068 5200 BC 's-Hertogenbosch http://www.brabantwater.nl Handelsregister: 16005077 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
