It works fine with dasd_configure (also). I rather use the cmd, just adding it to the 'add a disk' routine. So now no problems :) Thank's for all response !
___________________________________________ Tore Agblad Volvo Information Technology Infrastructure Mainframe Design & Development, Linux servers Dept 4352 DA1S SE-405 08, Gothenburg Sweden Telephone: +46-31-3233569 E-mail: [email protected] http://www.volvo.com/volvoit/global/en-gb/ -----Original Message----- From: Linux on 390 Port [mailto:[email protected]] On Behalf Of Antonio Silva Sent: den 10 april 2010 21:10 To: [email protected] Subject: Re: SLES11 one disk is not online at boot, mount fails (of course) The file /etc/modprobe.conf, contain the dasd adress for bring online att boot time. All adress of dasd should is insert in this file. After edit this file, should run mkinitrd and zipl -V. The adress 210 exist in this file?? 2010/4/4 Mark Post <[email protected]> > >>> On 4/4/2010 at 09:47 AM, Antonio Silva <[email protected]> > wrote: > > Before you execute zipl -V, insert in /etc/modprobe.conf the dasd adress > > (210) ??? > > No. > > > Mark Post > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO LINUX-390 or > visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
