>>> On 3/4/2014 at 03:16 PM, Tom Burkholder <[email protected]> wrote: > I just noticed that my DTCVSW2 controller is showing Error: BACKUP Not ready > from the q vswitch command (probably not a good thing). Looks like the paths > are online. Does anybody know how to get the backup controller DTCVSW2 back > into a *ready* state (without taking an TCPIP burp or outage)? This is a > z/VM 6.2 single VM system.
This question would likely get far more of a response on the IBMVM mailing list, but I'll give it a try. The problem isn't with DTCVSW2, just RDEV 160. You should probably check to make sure it's got a cable plugged in, that the physical switch sees it, etc. Perhaps look at the HMC to see if anything there shows problems with the card, etc. Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
