Probably not....the Linux world seemed easier for me to understand before all the "unification" efforts (like grub, systemd, et al). Just showing my age. Thanks for the explanation, Mark.
Thanks, Sam (217) 862-9227 (office) (602) 327-2134 (cell) -----Original Message----- From: Linux on 390 Port <[email protected]> On Behalf Of Mark Post Sent: Wednesday, April 22, 2020 8:29 AM To: [email protected] Subject: Re: BCACHE errors on lvextend, on reboot goes to dracut emergency mode On 4/22/20 11:21 AM, Cohen, Sam wrote: > FWIW, every time I run dracut, I then run zipl before IPLing. If you're doing this on a SLES system that's using grub2, I'm not at all sure zipl is doing what you think it is. The zipl command is *only* used to re-write the block locations for the "grub2 kernel" and "grub2 initrd" that are located in /boot/zipl. Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit https://nam04.safelinks.protection.outlook.com/?url=http%3A%2F%2Fwww2.marist.edu%2Fhtbin%2Fwlvindex%3FLINUX-390&data=02%7C01%7CSam.Cohen%40LRS.COM%7Ca87167062a3a43e7a99b08d7e6d25f21%7C62af9ccc42164ae2a1d306614c59c315%7C0%7C0%7C637231663537468614&sdata=3jPfPHpQfWGEx7elyso8FjuaqAFKLUQ5FgInAnRPCkE%3D&reserved=0 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www2.marist.edu/htbin/wlvindex?LINUX-390
