At 07:11 PM 04/14/2000, you wrote:
>If you have both CPU's in during install the default kernel will be
>SMP-enabled. (labelled: linux). It also installes a single cpu kernel
>(labelled: linux-up).
Both CPU's are installed.
>What is the error message you are getting? And precisely where are you
>getting it in the boot sequence?
I'm not getting an error. It just reboots. The two lines I see before the
reboot begin with 'hda' and 'hdc' - in reference to the hard disk and CDROM
drive. Then the screen goes blank because the reboot has begun. It will
go through this cycle indefinitely.
>It might be a bios problem. Identify what bios you are using by checking
>the last 2 letters of the bios version on the bios screen on the bottom
>left. I would suggest upgrading to the new QQ bios.
I will check into this.
Thanks!!
-Ray
> -Jon
>
>----- Original Message -----
>From: Ray J. Franks <[EMAIL PROTECTED]>
>To: <[EMAIL PROTECTED]>
>Sent: Friday, April 14, 2000 7:49 PM
>Subject: [LINUX-ABIT] Autoreboot problem
>
>
>After installing RedHat 6.1, Workstation or server, my computer kicks out
>about a page of info after the Lilo prompt and then reboots immediately
>after the hda and hdc output lines. I am running dual 500MHz
>celerons. Does anyone have a solution for this?
>
>If I type linux-up at the lilo prompt, the machine comes up just fine.
>
>Thanks,
>-Ray
>
>--
>=- To unsubscribe, email [EMAIL PROTECTED] with the -=
>=- body of "unsubscribe linux-abit". -=
>
>
>--
>=- To unsubscribe, email [EMAIL PROTECTED] with the -=
>=- body of "unsubscribe linux-abit". -=
--
=- To unsubscribe, email [EMAIL PROTECTED] with the -=
=- body of "unsubscribe linux-abit". -=
