I have just acquired an EtherB card (ANT) and checked the FAQ and see that Ether3 support now supports EtherB. Good 'cause I was thinking I was going to have to do it myself. I've rebuilt 2.0.36 but inmod'ing ether3 results in an error. eth0: unable to identify podule bus width. The card is sitting on the network interface in my RPC. Has this been fixed? Do I need a later driver/kernel? Thanks Melanie -- ===================================================================== Melanie Rhianna Lewis [EMAIL PROTECTED] "An it hurt none, do what thou will" http://www.defaid.demon.co.uk TLBB#2 TGMCC#1 - GS550 (In the front yard), X7 (Dead), MZ 125TS (Ill) ===================================================================== unsubscribe: body of `unsubscribe linux-arm' to [EMAIL PROTECTED]
