On Wed, 12 May 1999 [EMAIL PROTECTED] wrote:
> I'm using isapnptools v1.18. My isapnp.conf file is included below, or,
>at least that part of it dealing with the sound card.
Here's a copy of mine (which works). I have deleted all of the comments and
blank lines. Compare it with yours.
(READPORT 0x0203)
(ISOLATE PRESERVE)
(IDENTIFY *)
(CONFIGURE CTL00c5/63091016 (LD 0
(INT 0 (IRQ 5 (MODE +E)))
(DMA 0 (CHANNEL 1))
(DMA 1 (CHANNEL 5))
(IO 0 (BASE 0x0220))
(IO 1 (BASE 0x0330))
(IO 2 (BASE 0x0388))
(ACT Y)
))
(WAITFORKEY)
>I have sound
>compiled directly in to my kernel, 2.2.7, and am inserting the module
>uart401 as instructed in the file
>/usr/src/linux/Documentation/sound/Soundblaster, this module goes in
>fine. I'm then doing
>insmod sb io 0x220 irq 5 dma8 1 dma16 5
I haven't upgraded to the 2.2 kernel yet, so I'm not sure of the precise
syntax, but a problem might be that you're not passing in all of the addresses.
Perhaps you should be specifying "io 0x220,0x330,0x388".
--
Dave Mielke | 856 Grenon Avenue | I believe that the Bible is the
Phone: 1-613-726-0014 | Ottawa, Ontario | Word of God. Please contact me
EMail: [EMAIL PROTECTED] | Canada K2B 6G3 | if you're concerned about Hell.
