I have an ATI AGP card in my computer for my primary display.
I recently installed a TSeng ET6000 adapter I had lying around to try to run
a setup with two monitors (running and additional server on display :1).
Beneath you can see the output from lspci -vv. As you can see, the
ET6000-card has been disabled by the PCI BIOS, and I have a hard time
figuring out what arguments to use with setpci to enable it again.
I have configured my XF86Config for both cards (on with Mach64 and the other
with SVGA), but if I try to start XF86_SVGA :1 it just starts up on the
ATI-card. I suspect this is the trick to get it working. Am I right?
I'm also wondering wheter or not my ATI-card is working at full speed
(66MHz- option).
Any information in this matter would be greatly appreciated.
00:0d.0 VGA compatible controller: Tseng Labs Inc ET6000 (rev 60)
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping-
SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 11
Region 0: Memory at e5000000 (32-bit, non-prefetchable) [disabled]
Region 1: I/O ports at ec00 [disabled]
01:00.0 VGA compatible controller: ATI Technologies Inc 215GB [Mach64 GB] (rev 5c)
Subsystem: Unknown device 1002:0062
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+
SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 8 min, 32 set, cache line size 08
Interrupt: pin A routed to IRQ 9
Region 0: Memory at e0000000 (32-bit, non-prefetchable)
Region 1: I/O ports at d000
Region 2: Memory at e2000000 (32-bit, non-prefetchable)
Capabilities: <available only to root>
TIA
-- Robin
Please CC directly to me, as I'm not on the list.
--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Robin Smidsr�d | Private: 33317202 | Web : http://www.smidsrod.no/
Gauter�dvn. 100 | Mobile : 91593393 | E-Mail : [EMAIL PROTECTED]
N-3114 T�NSBERG | Fax : 33317201 | CellMail: [EMAIL PROTECTED]
