Hi All,
I am running a Redhat 6.1 server. It is on a LAN. Linux is able to detect
the Ethernet card and the ip assigned to it. I had configured this during
the installation process.
Now I have put in another Ethernet card( i.e., I have now two NICs) which
is a generic ne2000
comapitble card and runs on io=0x300 irq=5. I configured the second
adapter with this information and a different IP address(linuxconf). I
am able to
detect the card through modprobe and then activate the changes through
linuxconf. The card is then activated and I can see then current
configuration with ifconfig.
But, the problem is these changes do not remain permanent, because after a
reboot I have to redo the whole process of detecting and activating. How
do I hard code these changes? or make them permanent.
Help required urgently
TIA
Regards,
Sanvir
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Sanvir Singh Jham Tel: 694 1831/6619/6612/8617
Velocient Technologies Limited Fax: 694 3732
New Delhi E-Mail:[EMAIL PROTECTED]
[EMAIL PROTECTED]
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Just Believe in the Best
The mailing list archives are available at
http://lists.linux-india.org/cgi-bin/wilma/linux-delhi/
