There is a "connect-timeout" command is the diald config.
>From the man page:
connect-timeout <t>
Set the maximum amount of time to wait for the connect script to
complete to <t> seconds. The default is 60 seconds.
Try to set it to a larger value.
Kind regards,
Jeroen de Boer
On Wed, 18 Aug 1999, Noel Thompson wrote:
> Hi there,
>
> I have installed diald on quite a few linux boxes. I have never had this
> problem before. The machine is a 486 33mhz with 32 mb ram. It is running red
> hat 5.0.
>
> When diald is started everthing runs fine, it does the connect script, it
> sends username and password to the ISp but just before it is assigned an IP
> address and pppd starts, gives message "conect script timed out" it then
> drops the line and tries again. Sometimes it gets through but this is a
> problem.
>
> I saw on the diald home page under FAQ, that I should add two extra lines in
> /etc/resolve.conf add two extra identical nameservers. I have done this and
> it seemed to help slightly the script gets further than it did before I did
> this.
>
> Any other suggestions would be greatly appreciated.
>
> regards
> Noel Thompson
> Internet Unlimited
> [EMAIL PROTECTED]
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-diald" in
> the body of a message to [EMAIL PROTECTED]
>
-
To unsubscribe from this list: send the line "unsubscribe linux-diald" in
the body of a message to [EMAIL PROTECTED]
