Hi there, I bought a new DiSEqC switch which works perfectly with all other satellite receivers but not with the DVB-S card. There are two different reasons why it does not work:
- If using a full DiSEqC message (Addr.0x10, Command 0x38) the timing is terrible: Between the paritiy bit and the first bit of the next byte there is a gap which enlarges the last bit by 15%. This makes the DiSEqc decoder (a PIC 16C505) losing its bit sync. - If using a simple SA/SB tone burst it would work, but there is an error in the implementation of SEC_MINI_B. According to the specification there should be 9 one's (500us 22khz followed by 1ms 0hz) within 12.5ms but unfortunately nothing is transmitted. I would be very happy if someone could fix the problems in the firmware. Deti -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
