When looking up the IRQ the bank offset needs to be taken into account. Otherwise interrupts for banks other than bank 0 get incorrectly reported as interrupts for bank 0.
Signed-off-by: Lars-Peter Clausen <[email protected]> --- Changes since v1: * Use lookup table instead of switch-case. --- drivers/gpio/gpio-zynq.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/drivers/gpio/gpio-zynq.c b/drivers/gpio/gpio-zynq.c index f440317..5db1af7 100644 --- a/drivers/gpio/gpio-zynq.c +++ b/drivers/gpio/gpio-zynq.c @@ -138,6 +138,13 @@ static inline void zynq_gpio_get_bank_pin(unsigned int pin_num, } } +static const unsigned int zynq_gpio_bank_offset[] = { + ZYNQ_GPIO_BANK0_PIN_MIN, + ZYNQ_GPIO_BANK1_PIN_MIN, + ZYNQ_GPIO_BANK2_PIN_MIN, + ZYNQ_GPIO_BANK3_PIN_MIN, +}; + /** * zynq_gpio_get_value - Get the state of the specified pin of GPIO device * @chip: gpio_chip instance to be worked on @@ -461,6 +468,7 @@ static void zynq_gpio_handle_bank_irq(struct zynq_gpio *gpio, unsigned int bank_num, unsigned long pending) { + unsigned int bank_offset = zynq_gpio_bank_offset[bank_num]; struct irq_domain *irqdomain = gpio->chip.irqdomain; int offset; @@ -470,7 +478,7 @@ static void zynq_gpio_handle_bank_irq(struct zynq_gpio *gpio, for_each_set_bit(offset, &pending, 32) { unsigned int gpio_irq; - gpio_irq = irq_find_mapping(irqdomain, offset); + gpio_irq = irq_find_mapping(irqdomain, offset + bank_offset); generic_handle_irq(gpio_irq); } } -- 1.8.0 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
