Hello, I am here again.. :D
Andrew Beekhof escribió:
On 7/19/07, Adrian Chapela <[EMAIL PROTECTED]> wrote:
Andrew Beekhof escribió:
On 7/19/07, Adrian Chapela <[EMAIL PROTECTED]> wrote:
Andrew Beekhof escribió:
then you want:
default_resource_failure_stickiness=-INFINITY (if it fails, move
immediately), and
default_resource_stickiness=INFINITY (dont move it unless it fails or
the node is shutting down or similar)
But If I assign default_resource_stickiness=INFINITY , the resource
group executes in the first heartbeat node available no ??
it has no relation to the initial placement (since its not yet running)
OK, but if by any cause I startup the secondary node first the primary
node, the resource group will go to the primary node??
How Can I have a rule/attribute/something wich assign initial placement
to the same node ???
define "same"?
I have two nodes: first node is named node1 and second node is named node2.
I want to run resource group in node1 and only if this node fails, the
resource group must be moved to node2.
One thing, if node2 startup before than node1, I want when node1 goes up
it must run the resource group. Is thi s possible ??
Now I assign a 200 score to a node by a rule, could be this rule the
problem ?? The rule is:
not really a problem, but it will of course have an effect
In my case the effect can change the final score when a node fails ??
if the node isnt the one listed in the rule - then of course.
otherwise no.
unless its the pingd rule that is preventing some of the nodes from
taking over the resource
I don't understand, If the pingd has the same value in the two nodes
(two nodes have not network failures...) the pingd rule hasn't a effect
at all no ?? The rule has only effect in a node with network problems, I
think ..
it depends on how you write the rule(s)
We can forget pingd for all, but Can you write me a rule to do what I
want ??
I want a resource group running a node1 until this node fails. When this
node fails resource group must be moved to node2 and then it never can
be moved to the node1 again.
Also, I need a clone to run a resource in two nodes at the same time. If
this clone fails, resource group must be moved to node2... etc...
This is I want but is it possible ?? I think not. What do you think ??
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
