I have setup STONITH on my two-node cluster using a Baytech RPC-3 as the underlying hardware. It works in that if node B fails, then node A performs a power cycle on it. However, it continues to power-cycle the node every 30 seconds or so and node B never gets a chance to come back up again. I have been searching for a setting to change the amount of time that node A waits for node B to become available before killing it again but I can't find anything. A way to make it only try once even if node B does not come up would be fine also, after all if it doesn't come back after one power cycle, it's not likely to after ten either. Any tips? David
_______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
