On Dec 31, 2007, at 4:07 PM, David S. Madole wrote:
I have setup STONITH on my two-node cluster using a Baytech RPC-3 as
the underlying hardware.
It works in that if node B fails, then node A performs a power cycle
on it. However, it continues to power-cycle the node every 30
seconds or so and node B never gets a chance to come back up again.
I have been searching for a setting to change the amount of time
that node A waits for node B to become available before killing it
again but I can't find anything. A way to make it only try once even
if node B does not come up would be fine also, after all if it
doesn't come back after one power cycle, it's not likely to after
ten either.
Any tips?
version? configuration? logs?
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
