Well if you are going to transmit anything sensitive (I.E. you dont want
everyone to read it) or is for business use then amateur radio is out. I
would reccomend spread spectrum. California microwave has some nice 900mhz
units that transmit about 10 miles are fairly in-expensive and dont require
ax25 or other special setups. they act as if it was a direct serial
connection (with a bit of lag)
About $400.00 per unit less power supply,antennas, cables, technician.
-----Original Message-----
From: Gabriel Calin <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
Date: Sunday, June 27, 1999 2:46 PM
Subject: Radio connection
>Hello all
>
>I just joined this maillist. I have big problem to
>solve and some people told me there're some gurus
>around here.
> This is the problem. I have two servers about 3km
>apart (1.6 miles) and I have to conect them using a
>radio system. The connection speed is not a problem
>(9600 would be fine), but the $$ to do that is a
>little bit limited. To make things worst, there's a
>building in the way, so I have to transmist the
>signal to the top of the building and then back down
>to the other server.
> I'm really new on this radio area, so i'd appreciate
>some help pointing to possible solutions I could use
>(concerning about hardware and software protocols).
>
>I'd really appreciate any help
>
>Gabriel Calin
>
>_________________________________________________________
>DO YOU YAHOO!?
>Get your free @yahoo.com address at http://mail.yahoo.com
>
