Hello all!
I'm trying to configure my USCC card to work in 9k6, with no success.
I can stablish the link, but there are about 50% loss of incoming
frames.
The same hardware, running BayCom under DOS, works well; so, I can
discard hardware failure.
I have played a lot with the ax25 config parameters, with no results.
Below, a description of my system:
Intel 486DX2-66, 8 Mb RAM, linux slackware 2.0.29, z8530drv-2.4c,
USCC card Microlaser (BayCom like), radio TEKK KS900.
Any ideas to help?
TIA
Schneider - py5vs
