Hi all!
I am having some problems with NET/ROM and IP over NET/ROM....
From my home QTH I can reach directly only one TheNet Node, called
BO2:IR4BO-2, which is connected to other nodes.
If I manually connect to BO2:IR4BO-2 then I can connect easily any node.
The problem arises when I configure NET/ROM to do so automatically...
This is the way I go:
nrparms -nodes IR4BO-2 + BO2 120 6 radio IR4BO-2 # my
node/neighbour, the only one I can reach directly
nrparms -nodes IR4TCP-8 + '*' 90 6 radio IR4BO-2
nrparms -nodes IV3KZY-8 + '*' 90 6 radio IR4BO-2 # 2 nodes
which I can connect manually
at this time I think I could connect both IR4TCP-8 and IV3KZY-8 by using
"call netrom IR4TCP-8" or "call netrom IV3KZY-8" but the connection never
happens... I can't figure why this is happening, if I directly connect
IR4BO-2 and then issue a "c IV3KZY-8" or "c IR4TCP-8" all is ok...where am
I wrong?
Another problem (is it connected in some way to the previous one?) arises
when I try to use TCP/IP over this TheNet node (BO2:IR4BO-2).
My IP number (IZ4AFW) is: 44.134.193.80
Target IP number (IR4TCP) is: 44.134.192.252
My packets need to go through BO2:IR4BO-2, a TheNet node with no IP address.
So I tried:
nrparms -nodes IR4BO-2 + BO2 120 6 radio IR4BO-2 #to setup
my neighbour/node
route add 44.134.192.252 nr0
arp -t netrom -s 44.134.192.252 IR4BO-2 # as in AX-25 HOWTO
When I try to ping IR4TCP (44.134.192.252) I always get 100% packet loss
[moreover with this config I can't get packets go out of my baycom modem].
The system configuration is Slackware 4.0, ax25-utils-2.1.42a, and a 1200
bps baycom modem. Kernel 2.2.13
Please help me solving this annoying problem!
Thanks in advance, and all the best in the New Year!!
Ciao from Italy,
Fabio
IZ4AFW
Effugere nemo id potest, quod futurum est. (Publilio Siro)
--
EMail [EMAIL PROTECTED]
[EMAIL PROTECTED]
[EMAIL PROTECTED]
[EMAIL PROTECTED]
FidoNet 2:332/413.15
- PGP key available on request -
Home Page http://surf.to/manto *OR*
http://www.qsl.net/iz4afw
