Hello Bryan
Is the tiny dropping back to TNC2 command mode.
hence when data is sent to the tiny2 the STA led is on, indicating data
waiting to be sent.
Easy to test if you have a second PC and a terminal program and do a
ctl/c and see if it responds cmd:
Had this before on my test bsx tnc. I run 7 tiny2's on my server.
hope that helps overcome your problem
regards
Paul g4apl@gb7cip
In message <[EMAIL PROTECTED]>, Brian Wilde
<[EMAIL PROTECTED]> writes
>Hi All
>
>When I reboot Linux having left the Tiny2 in kiss mode the STA led remains on
>when I try to connect to a station. The PTT led does try to send packets but no
>connect results. If I reset the Tiny2 by switching on-off then the STA led
>goes out but I can not receive any packets. If I try a connect again then the
>STA light remains on as above.
>
>When I first set up from the TNC being in the command mode I do the following
>and its OK.
>
>Boot Linux (Debian 2.1) kernel 2.2.14
>Put TNC in kiss mode with Minicom.
>start Kissattach
>start LinPac
>
>Linpac is working fine!
>Shut down Linux leaving TNC in kiss mode
>reboot Linux
>start Kissattach
>start LinPac
>
>Then the above problem occurs
>I have cleared out the TTY lock file in /var/lock with no effect.
>
>Help please
>
>CU 73's Brian
>G3VWH
>
--
[EMAIL PROTECTED]
