Hi All
Thanks to Richard & Paul for your notes on the Tiny2 jumping back to command
mode.
I have checked this out but it appears that the TNC is remaining in Kiss mode.
So I rebooted to DOS and used Paket6 to put the TNC
back to the command mode with Alt k
The TNC runs fine in kissmode with DOS/BPQ and
with Windows98 running AGW Packet engine.
I have since noted that the TNC does not receive any packets when it has the
STA light problem. Restarting the TNC with the on/off switch has no effect
other than cancelling the STA light but still no packets are received.
I have found the only way to get it to work is to start with the TNC in command
mode and then put it in kissmode from Linux. I can only think that on shutdown
some rubbish is being left on the TNC but I would have thought that a restart
would clear that.
I have also used the call programme with the same results.
I have managed to set up my Baycom board on bcsf0 and that works fine under
Linpac. :-)
I did an "ifconfig" and ax0 is up and running as normal
Interesting problem I suppose it might be a duff Tiny2!
CU
73's Brian
