----- Original Message -----
From: G A Abhay <[EMAIL PROTECTED]>
> So i decided to run Xconfigurator in setup. There i probed , and added the
> lower resolutions too. Therefore 8bits,16bits and 24bits
> ,(640*..,..,1024x768 of each)
>
> Now this is what is happening: if i do cntr + alt + '+'
> i see only 2 resolutions now , the earlier default resolution which the
> Xconfig says , 32bit, 1024x768 cant be seen,therefore the screen goes
> blank(black) and the signal to the monitor (shown next to the poweron)
> goes red instead of being green. Now this default resolution is needed .
Check the frequency settings for the monitor
that you gave Xconfigurator.
Your video card is using a frequency that
will not be accepted by your monitor (it
may be too high). Some monitors are designed
to "switch off" in such cases to avoid damage.
Use xf86config and enter the values using
the data from your monitor manual.
Or just edit /etc/X11/XF86Config and change
the values.
-Sharat-
-----------------------------------------------------------------------
For more information on the LIH mailing list see:
http://lists.linux-india.org/lists/LIH
