Hi
Run netconf (or netconfig) and set the setting for both the
adaptors to manual and enter an appropriate IP address.. I do not have much
experience but this shud work......
At 11:47 PM 7/18/00 +0530, you wrote:
>hey luggers........
>somebody help me out...am going crazy bcos of my ethernet card....... the
>specifications of my system and the problem follows
>
>i have a AMD K6-II 500Mhz , 64mb Ram and stuff....... along with 2 network
>card
>1. Compex 10/100Mbps (RL100ATX-PCI)---- (mod) rl100a.o
>2. Dax 10/100Mbps -------------------------- (mod) rtl8139.o
>
>the cards are not faulty as they work perfectly in windows
>
>Please do not suggest to get a new one, cause got rtl8139.o yesterday when i
>came to know that rl100a.o wont work for me...... i am finally back ,using
>Red hat linux 6.2 again after trying Caldera 2.4
>
>the problem is the same am not able to configure the eth0 (using both the
>cards)......have twice installed rhl6.2..... does not auto detect at time of
>installation(that applies for both cards)
>
>this is what all i have already tried........ but still see each time the
>same message while booting
>
>"bringing up interface eth0 delaying eth0 initialisation
>[FAILED]"(IN RED---started hating it)
>
>1. "insmod rtl8139.o" shows
>
> rtl8139.o : init_module : Device or resource busy
>so far so good....always think that..
>
>2. "/sbin/depmod -a" gives no error
>
>3. edited /etc/conf.modules with
>
> alias eth0 rtl8139.o
> options rtl8139.o io=0x000 irq=10 ## windows
>value on same comp irq=10 io=f000
>
>4. hence " modprobe -c" has thhe following lines in the result
> alias eth0 rtl8139.o
> options rtl8139.o io=0x000 irq=10
>no other line have eth0
>
>
>tho all this gives a good feeling but still at boot time it shows that
>[FAILED]
>
>have tried compiling with the following step
>
>
>
>
>
>
>
>
>gcc -DMODULE -D__KERNEL__ -I/usr/src/linux/net/inet -Wall -Wstrict-prototype
>s -O6 -c rtl8139.c -DMODVERSIONS
>
>but this also did not help....gave some error with depmod -a
>
>so please suggest some possible solution for letting my system to
>communicate with others i have
>and does not show on
>"ping 192.168.1.1"
>network unreachable
>
>reply asap
>abhishek
>
>
>__________________________________________________
>Do You Yahoo!?
>Talk to your friends online with Yahoo! Messenger.
>http://im.yahoo.com
>
>-----------------------------------------------------------------------
>The LIH mailing list archives are available at:
>http://lists.linux-india.org/cgi-bin/wilma/linux-india-help
--------Jayant
Take a look at my website over <http://jayantkumar.50megs.com/>here .....
----------------------------------------------------------------------
The LIH mailing list archives are available at:
http://lists.linux-india.org/cgi-bin/wilma/linux-india-help
