On Thu, 21 Dec 2000, manish wrote:
> hi
> has'nt any linux guru hacked a solution for motorola SM56 pci internal modem
> to make them work in linux?
>
> ok guys (hey jiju/suresh/sudhakar etc... or any one listening) could someone
> really help me with this output of me catting proc/pci
> Communication controller: Unknown vendor Unknown device (rev 0).
> Vendor id=11d4. Device id=1805.
> Medium devsel. Fast back-to-back capable. IRQ 11. Master Capable.
> Latency=32. Min Gnt=1.Max Lat=255.
> Prefetchable 32 bit memory at 0xe1000000 [0xe1000008].
Aargh... Where's the I/O Address ? Are you sure u posted the complete
listing ? Basically setserial would look something like:
setserial <Device> uart <Uart> port <IO_Addr> irq <IRQ>
For example, I set my internal PCI modem as:
setserial /dev/ttyS3 uart 16550A port 0x6700 irq 5
After doing a setserial, normally I use minicom (the reliable, simple, old
minicom !) to check out the modem, by issuing AT commands.
Sreeji
----------------------------------------------
The mailing list archives are available at
http://lists.linux-india.org/cgi-bin/wilma/LIH
