The processor is very much supported. Most likely LILO hasn't been
installed properly. You will have to boot linux from a diskette and
reinstall LILO on the MBR. Also add the line
lba32
to the /etc/lilo.conf file if it isn't already there and remove
"linear".
The driver module for your NIC is rtl8139.o - it should be there in Red
Hat Linux 7.0. Add the following line to /etc/modules.conf
alias eth0 rtl8139
If the vendor has provided a linux driver for the card, install that on
your system and replace the existing rtl8139.o
HTH,
Manish
http://www.tuxspace.com/
Ritesh wrote:
>
> Dear All,
>
> I had problem installing linux 7.0
>
> The hardware configuration is as follows.
>
> Intell 810 board.
> Cyrrix ||| 500mhz processor.
> Crystall sound chip ( onboard)
> 128 mb ram
> on board agp
> samtron 55v 15" colour monitor.
> Dlink 538tx ethernet card.
> Harddisk. 20 gb
> Partitions 4
> C: 7 gb(windows)
> d: 4.5
> E: 4.5
> F: 3.5 (linux)
>
> I used the fourth partition to install linux.
> My windows 98 is in C:
>
> The installation went fine.It didnt detected the NIC.Installed LILO in MBR
>
> After rebooting the lilo didnt showed nor it booted in to linux.
> It booted normally in windows 98.
>
> I think that it doesnt support Cyrix ||| 500 mhz processor.
>
> If anyone had encounter with similar problem please let me know.
>
> And solution also.
>
> Regards,
>
> Ritesh Agrawal.
>
> --
----------------------------------------------
The mailing list archives are available at
http://lists.linux-india.org/cgi-bin/wilma/linux-india-help
