Konstantinos Agouros wrote :
> Hello,
>
> I have an Omnibook 6000 which has the nsc-chip. Since I used irda only
> with serial connectors (actisys) I tried getting it to run, and managed
> to see packets coming in using irdadump and my psion sending, but I couldn't
> send anything.
> I modprobed the chip with ID 0x08 and tried /dev/ircomm0 to connect to my
> mobile phone, but irdadump didn't show any outgoing packets. I also did
> a setserial /dev/ttyS1 uart none before the modprobe. Could someone give me
> a hint?
>
> Konstantin
This sounds proper.
For me, it works fine. I documented it in :
http://www.hpl.hp.com/personal/Jean_Tourrilhes/IrDA/squirt.html#tutorial
I would check the Bios and *remove* the serial module. Check
irdadump before starting the IrComm and try with something else than a
phone (phones are quirky and you may need to enable IrDA on it).
Jean
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
