Patrick-Thomas Chmielewski wrote:
> SIR Base 0x3f8, FIR Base 0x3f8
> IRQ = 4, DMA = 0
>
> But i was not able to load the nsc-ircc.o. It says that it couldn't find the
> hardware....
> Is there anybody else using FIR on L8400-K?
> What is the dongle-id of this notebook?
> How to load this module?
I have an L8400-B and the dongle_id is 0x09.
Before you load nsc-ircc you should tell the
serial-driver not to use your irda-hardware
bu running:
#setserial /dev/ttyS1 uart none
/Pontus Fuchs
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
