Am Montag, 11. Juni 2001 10:11 schrieben Sie:
> Patrick-Thomas Chmielewski wrote:
> > SIR Base 0x3f8, FIR Base 0x3f8
> > IRQ = 4, DMA = 0
> >
> > But i was not able to load the nsc-ircc.o. It says that it couldn't find
> > the hardware....
> >
> > Is there anybody else using FIR on L8400-K?
> > What is the dongle-id of this notebook?
> > How to load this module?
>
> I have an L8400-B and the dongle_id is 0x09.
>
> Before you load nsc-ircc you should tell the
> serial-driver not to use your irda-hardware
> bu running:
Does the L8400-B have the same FIR-Chip (NSC)? A friend told me that there
are different FIR-Chips on -B and -K series.
What parameters I'll have to write in the suffix of ncc-ircc?
Thanx,
__________________________________________________________
| patrick-thomas chmielewski <[EMAIL PROTECTED]>
| homepage (+gpg public key) @ http://chmielewski-patch.de
| encrypt your emails! use GnuPG available @ www.GnuPG.org
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
