>
> On Thu, 2 Dec 1999, Brian Lawless wrote:
>
> >> I've found a very nice PDF file on http://mobileinternet.ericsson.se
> >> describing the AT commands of the SH888,
> >Yes this is a nice file but it is incorrect.
> >Page 152 gives a dial example with the SH888
> >ATD0705865975
> >This does not work. A ; (semicolon) is required after the
> >number to cause a dialling action but the software built
> >into the Ericsson SH888 then dials and switches the phone
> >back to voice mode. It is therefore impossible to
> >use the SH888 as a straightforward modem. I fail to see the
> >necessity for this software block.
> I had an idea here.
> What number are you calling when using the ; ?
> Is it a real data number, ie. does a modem pick up the line?
I have access to a landline modem and a dial in system. The
only change is that a SH888 replaced the Hayes
modem+landline.
> And, what does the SH888 reply to your ATD command (without ';') ?
>
ATD017099988
ERROR
So I do not think that it is a problem with the answering
modem and answering computer.
Regards
Brian
==============================================================
Brian Lawless tel :- +353-1-7045300
School of Physical Sciences fax :- +353-1-7045384
Dublin City University
Dublin 9 email :- [EMAIL PROTECTED]
Ireland
==============================================================
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www4.pasta.cs.UiT.No/mailman/listinfo/linux-irda
