Vladislav Cerny <[EMAIL PROTECTED]> writes:
> On 7 Jan 2000, Dag Brattli wrote:
>
> > Vladislav Cerny <[EMAIL PROTECTED]> writes:
> Now testing 2.2.15-pre5 and still have problems. I thing ifconfig and
> route stuff is OK (tested on eth0 and plip0 pointopoint link). I used
> irda0 instead of irlan0 before, but I have no success with irlan0 anyway.
You must do "ifup irlan0" on both computers. To me if sounds like you have
only done this one one of them. Try running irdadump, it should show that
both computers have LAN capability in the discovery frames (XID).
> Is it OK? Should it be broadcast or pointopoint link?
Yes it's OK!
> ?? irda0 Link encap:UNSPEC ??
You don't have IrDA suppor in your ifconfig program. If you don't want to
see the UNSPEC stuff then install the net-tools and recompile with IrDA
support. This is the default in RH-6.1
> ?? irlan0 Link encap:Ethernet HWaddr 00:00:00:00:00:00 ??
You haven't made contact with the other computer yet! Have you enabled
irlan on the other computer?
> HP4050N is working now (with Fast RR enabled). It does not want to work
> without "Fast RR". (Also printing from HP Velo500 handheld to HP5MP works,
> but to HP4050N does not. ???)
I'll do some testing without Fast RR's enabled, since it's a long time
since I've done it.
PS. If you get any problems with the Tekram dongle (I sometimes do), the
you'll need to do "ifconfig irda0 down up" to reset it again.
-- Dag
--
/ Dag Brattli | The Linux-IrDA Project /
// University of Tromsoe, Norway | Infrared communication for Linux //
/// http://www.cs.uit.no/~dagb | http://www.cs.uit.no/linux-irda/ ///
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www4.pasta.cs.UiT.No/mailman/listinfo/linux-irda
