[PATCH] HID: rmi: Check that the device is a RMI device in suspend and resume callbacks

[Andrew Duggan]

Commit 092563604217 ("HID: rmi: Disable scanning if the device is not a
wake source") introduced a regression for devices which use hid-rmi to
handle composite USB devices. The suspend or resume callbacks are not
checking that the device is a RMI device before calling rmi_read or
rmi_write. This results in dereferencing uninitialized variables on
non RMI devices. This patch checks that the RMI_DEVICE flag is set before
sending RMI commands to the device.

Reported-by: Rodrigo Gomes <rodrigo.toste.go...@gmail.com>
Signed-off-by: Andrew Duggan <adug...@synaptics.com>
---
 drivers/hid/hid-rmi.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/drivers/hid/hid-rmi.c b/drivers/hid/hid-rmi.c
index 67cd059..9cd2ca3 100644
--- a/drivers/hid/hid-rmi.c
+++ b/drivers/hid/hid-rmi.c
@@ -594,6 +594,9 @@ static int rmi_suspend(struct hid_device *hdev, 
pm_message_t message)
        int ret;
        u8 buf[RMI_F11_CTRL_REG_COUNT];
 
+       if (!(data->device_flags & RMI_DEVICE))
+               return 0;
+
        ret = rmi_read_block(hdev, data->f11.control_base_addr, buf,
                                RMI_F11_CTRL_REG_COUNT);
        if (ret)
@@ -613,6 +616,9 @@ static int rmi_post_reset(struct hid_device *hdev)
        struct rmi_data *data = hid_get_drvdata(hdev);
        int ret;
 
+       if (!(data->device_flags & RMI_DEVICE))
+               return 0;
+
        ret = rmi_reset_attn_mode(hdev);
        if (ret) {
                hid_err(hdev, "can not set rmi mode\n");
@@ -640,6 +646,11 @@ static int rmi_post_reset(struct hid_device *hdev)
 
 static int rmi_post_resume(struct hid_device *hdev)
 {
+       struct rmi_data *data = hid_get_drvdata(hdev);
+
+       if (!(data->device_flags & RMI_DEVICE))
+               return 0;
+
        return rmi_reset_attn_mode(hdev);
 }
 #endif /* CONFIG_PM */
-- 
2.5.0