Krzysztof Kozlowski writes: > On Tue, Sep 27, 2016 at 01:31:09AM +0200, Wolfgang Wiedmeyer wrote: >> For MAX77693, the fast charge current also needs to be manipulated for >> proper charging. The fast charge current is only set in the case of >> the MAX77693 type, as the MAX77843 properly manipulates the fast >> charge current. > > Are you sure it has to be manipulated? Some time I didn't dig into this. > Now I looked at the datasheet and it says that usually there is no need > for changing the charge current during the operation. Maxim recommends > to setting it to a maximum safe value for the battery. The device will > manage charge current on its own. > > However I agree that the charge current should be set... maybe once, to > a maximum value appropriate for battery. Probably this should be done > by max77693_charger in max77693_dt_init().
When charging is disabled (e.g. by removing the USB cable) the charge
current is not reset to zero. So if I expose the current by the
CURRENT_NOW property, it incorrectly reports the current that was set
when charging was enabled, although there is no charging going on
anymore. So I felt the need to update the charge current every time the
charger gets enabled or disabled.
Initially, the charge current is set to zero, so I think it needs to be
set at least at the beginning to enable charging.
Thanks,
Wolfgang
> Best regards,
> Krzysztof
>
>
>> The fast charge current is set to the next possible value below the
>> maximum input current.
>
>
>>
>> Signed-off-by: Wolfgang Wiedmeyer <wolf...@wiedmeyer.de>
>> ---
>> drivers/regulator/max77693-regulator.c | 45
>> +++++++++++++++++++++++++++++++---
>> 1 file changed, 42 insertions(+), 3 deletions(-)
>>
>> diff --git a/drivers/regulator/max77693-regulator.c
>> b/drivers/regulator/max77693-regulator.c
>> index cfbb951..e2f7584 100644
>> --- a/drivers/regulator/max77693-regulator.c
>> +++ b/drivers/regulator/max77693-regulator.c
>> @@ -54,14 +54,19 @@ struct chg_reg_data {
>> unsigned int linear_mask;
>> unsigned int uA_step;
>> unsigned int min_sel;
>> +
>> + bool set_fast;
>> + unsigned int fast_reg;
>> + unsigned int fast_mask;
>> };
>>
>> /*
>> * MAX77693 CHARGER regulator - Min : 20mA, Max : 2580mA, step : 20mA
>> * 0x00, 0x01, 0x2, 0x03 = 60 mA
>> * 0x04 ~ 0x7E = (60 + (X - 3) * 20) mA
>> - * Actually for MAX77693 the driver manipulates the maximum input current,
>> - * not the fast charge current (output). This should be fixed.
>> + * Actually for MAX77693 the driver manipulates the maximum input current
>> + * and the fast charge current (output) because the fast charge current
>> + * is not set.
>> *
>> * On MAX77843 the calculation formula is the same (except values).
>> * Fortunately it properly manipulates the fast charge current.
>> @@ -100,6 +105,8 @@ static int max77693_chg_set_current_limit(struct
>> regulator_dev *rdev,
>> const struct chg_reg_data *reg_data = rdev_get_drvdata(rdev);
>> unsigned int chg_min_uA = rdev->constraints->min_uA;
>> int sel = 0;
>> + unsigned int data;
>> + int ret;
>>
>> while (chg_min_uA + reg_data->uA_step * sel < min_uA)
>> sel++;
>> @@ -110,7 +117,35 @@ static int max77693_chg_set_current_limit(struct
>> regulator_dev *rdev,
>> /* the first four codes for charger current are all 60mA */
>> sel += reg_data->min_sel;
>>
>> - return regmap_write(rdev->regmap, reg_data->linear_reg, sel);
>> + ret = regmap_write(rdev->regmap, reg_data->linear_reg, sel);
>> + if (ret < 0)
>> + return ret;
>> +
>> + if (reg_data->set_fast) {
>> + /* disable fast charge if minimum value */
>> + if (sel == reg_data->min_sel)
>> + data = 0;
>> + else {
>> + /*
>> + * set the fast charge current to the closest value
>> + * below the input current
>> + */
>> + ret = regmap_read(rdev->regmap, reg_data->fast_reg,
>> + &data);
>> + if (ret < 0)
>> + return ret;
>> +
>> + sel *= reg_data->uA_step / 1000; /* convert to mA */
>> + data &= ~reg_data->fast_mask;
>> + data |= sel * 10 / 333; /* 0.1A/3 steps */
>> + }
>> +
>> + ret = regmap_write(rdev->regmap, reg_data->fast_reg, data);
>> + if (ret < 0)
>> + return ret;
>> + }
>> +
>> + return 0;
>> }
>> /* end of CHARGER regulator ops */
>>
>> @@ -197,6 +232,9 @@ static const struct chg_reg_data max77693_chg_reg_data =
>> {
>> .linear_mask = CHG_CNFG_09_CHGIN_ILIM_MASK,
>> .uA_step = 20000,
>> .min_sel = 3,
>> + .set_fast = true,
>> + .fast_reg = MAX77693_CHG_REG_CHG_CNFG_02,
>> + .fast_mask = CHG_CNFG_02_CC_MASK,
>> };
>>
>> #define max77843_regulator_desc_esafeout(num) {
>> \
>> @@ -237,6 +275,7 @@ static const struct chg_reg_data max77843_chg_reg_data =
>> {
>> .linear_mask = MAX77843_CHG_FAST_CHG_CURRENT_MASK,
>> .uA_step = MAX77843_CHG_FAST_CHG_CURRENT_STEP,
>> .min_sel = 2,
>> + .set_fast = false,
>> };
>>
>> static int max77693_pmic_probe(struct platform_device *pdev)
>> --
>> 2.8.0.rc3
>>
--
Website: https://fossencdi.org
OpenPGP: 0F30 D1A0 2F73 F70A 6FEE 048E 5816 A24C 1075 7FC4
Key download: https://wiedmeyer.de/keys/ww.asc
signature.asc
Description: PGP signature
