Use the descriptor-based interface to manipulate GPIOs, instead of
the legacy integer-based interface.
In the meanwhile, remove unneeded vbus_pin_active_low[...] member.
Signed-off-by: Wenyou Yang <wenyou.y...@atmel.com>
---
drivers/usb/host/ohci-at91.c | 120 ++++++++++---------------------------------
1 file changed, 28 insertions(+), 92 deletions(-)
diff --git a/drivers/usb/host/ohci-at91.c b/drivers/usb/host/ohci-at91.c
index d177372..b0c7827 100644
--- a/drivers/usb/host/ohci-at91.c
+++ b/drivers/usb/host/ohci-at91.c
@@ -14,8 +14,8 @@
#include <linux/clk.h>
#include <linux/dma-mapping.h>
+#include <linux/gpio/consumer.h>
#include <linux/of_platform.h>
-#include <linux/of_gpio.h>
#include <linux/platform_device.h>
#include <linux/platform_data/atmel.h>
#include <linux/io.h>
@@ -36,11 +36,10 @@
#define AT91_MAX_USBH_PORTS 3
struct at91_usbh_data {
- int vbus_pin[AT91_MAX_USBH_PORTS]; /* port power-control pin */
- int overcurrent_pin[AT91_MAX_USBH_PORTS];
+ struct gpio_desc *vbus_pin[AT91_MAX_USBH_PORTS];
+ struct gpio_desc *overcurrent_pin[AT91_MAX_USBH_PORTS];
u8 ports; /* number of ports on root hub
*/
u8 overcurrent_supported;
- u8 vbus_pin_active_low[AT91_MAX_USBH_PORTS];
u8 overcurrent_status[AT91_MAX_USBH_PORTS];
u8 overcurrent_changed[AT91_MAX_USBH_PORTS];
};
@@ -243,11 +242,7 @@ static void ohci_at91_usb_set_power(struct at91_usbh_data
*pdata, int port, int
if (!valid_port(port))
return;
- if (!gpio_is_valid(pdata->vbus_pin[port]))
- return;
-
- gpio_set_value(pdata->vbus_pin[port],
- pdata->vbus_pin_active_low[port] ^ enable);
+ gpiod_set_value(pdata->vbus_pin[port], enable);
}
static int ohci_at91_usb_get_power(struct at91_usbh_data *pdata, int port)
@@ -255,11 +250,7 @@ static int ohci_at91_usb_get_power(struct at91_usbh_data
*pdata, int port)
if (!valid_port(port))
return -EINVAL;
- if (!gpio_is_valid(pdata->vbus_pin[port]))
- return -EINVAL;
-
- return gpio_get_value(pdata->vbus_pin[port]) ^
- pdata->vbus_pin_active_low[port];
+ return gpiod_get_value(pdata->vbus_pin[port]);
}
/*
@@ -406,16 +397,13 @@ static irqreturn_t ohci_hcd_at91_overcurrent_irq(int irq,
void *data)
{
struct platform_device *pdev = data;
struct at91_usbh_data *pdata = dev_get_platdata(&pdev->dev);
- int val, gpio, port;
+ int val, port;
/* From the GPIO notifying the over-current situation, find
* out the corresponding port */
at91_for_each_port(port) {
- if (gpio_is_valid(pdata->overcurrent_pin[port]) &&
- gpio_to_irq(pdata->overcurrent_pin[port]) ==
irq) {
- gpio = pdata->overcurrent_pin[port];
+ if (gpiod_to_irq(pdata->overcurrent_pin[port]) == irq)
break;
- }
}
if (port == AT91_MAX_USBH_PORTS) {
@@ -423,7 +411,7 @@ static irqreturn_t ohci_hcd_at91_overcurrent_irq(int irq,
void *data)
return IRQ_HANDLED;
}
- val = gpio_get_value(gpio);
+ val = gpiod_get_value(pdata->overcurrent_pin[port]);
/* When notified of an over-current situation, disable power
on the corresponding port, and mark this port in
@@ -454,9 +442,8 @@ static int ohci_hcd_at91_drv_probe(struct platform_device
*pdev)
struct device_node *np = pdev->dev.of_node;
struct at91_usbh_data *pdata;
int i;
- int gpio;
int ret;
- enum of_gpio_flags flags;
+ int err;
u32 ports;
/* Right now device-tree probed devices don't get dma_mask set.
@@ -477,36 +464,12 @@ static int ohci_hcd_at91_drv_probe(struct platform_device
*pdev)
pdata->ports = ports;
at91_for_each_port(i) {
- /*
- * do not configure PIO if not in relation with
- * real USB port on board
- */
- if (i >= pdata->ports) {
- pdata->vbus_pin[i] = -EINVAL;
- pdata->overcurrent_pin[i] = -EINVAL;
- continue;
- }
-
- gpio = of_get_named_gpio_flags(np, "atmel,vbus-gpio", i,
- &flags);
- pdata->vbus_pin[i] = gpio;
- if (!gpio_is_valid(gpio))
- continue;
- pdata->vbus_pin_active_low[i] = flags & OF_GPIO_ACTIVE_LOW;
-
- ret = gpio_request(gpio, "ohci_vbus");
- if (ret) {
- dev_err(&pdev->dev,
- "can't request vbus gpio %d\n", gpio);
- continue;
- }
- ret = gpio_direction_output(gpio,
- !pdata->vbus_pin_active_low[i]);
- if (ret) {
- dev_err(&pdev->dev,
- "can't put vbus gpio %d as output %d\n",
- gpio, !pdata->vbus_pin_active_low[i]);
- gpio_free(gpio);
+ pdata->vbus_pin[i] = devm_gpiod_get_optional(&pdev->dev,
+ "atmel,vbus-gpio",
+ GPIOD_IN);
+ if (IS_ERR(pdata->vbus_pin[i])) {
+ err = PTR_ERR(pdata->vbus_pin[i]);
+ dev_err(&pdev->dev, "unable to claim gpio \"vbus\":
%d\n", err);
continue;
}
@@ -518,37 +481,21 @@ static int ohci_hcd_at91_drv_probe(struct platform_device
*pdev)
break;
pdata->overcurrent_pin[i] =
- of_get_named_gpio_flags(np, "atmel,oc-gpio", i, &flags);
-
- if (!gpio_is_valid(pdata->overcurrent_pin[i]))
- continue;
- gpio = pdata->overcurrent_pin[i];
-
- ret = gpio_request(gpio, "ohci_overcurrent");
- if (ret) {
- dev_err(&pdev->dev,
- "can't request overcurrent gpio %d\n",
- gpio);
+ devm_gpiod_get_optional(&pdev->dev,
+ "atmel,oc-gpio", GPIOD_IN);
+ if (IS_ERR(pdata->overcurrent_pin[i])) {
+ err = PTR_ERR(pdata->overcurrent_pin[i]);
+ dev_err(&pdev->dev, "unable to claim gpio
\"overcurrent\": %d\n", err);
continue;
}
- ret = gpio_direction_input(gpio);
- if (ret) {
- dev_err(&pdev->dev,
- "can't configure overcurrent gpio %d as
input\n",
- gpio);
- gpio_free(gpio);
- continue;
- }
-
- ret = request_irq(gpio_to_irq(gpio),
- ohci_hcd_at91_overcurrent_irq,
- IRQF_SHARED, "ohci_overcurrent", pdev);
- if (ret) {
- gpio_free(gpio);
- dev_err(&pdev->dev,
- "can't get gpio IRQ for overcurrent\n");
- }
+ ret = devm_request_irq(&pdev->dev,
+ gpiod_to_irq(pdata->overcurrent_pin[i]),
+ ohci_hcd_at91_overcurrent_irq,
+ IRQF_SHARED,
+ "ohci_overcurrent", pdev);
+ if (ret)
+ dev_info(&pdev->dev, "failed to request gpio
\"overcurrent\" IRQ\n");
}
device_init_wakeup(&pdev->dev, 1);
@@ -561,19 +508,8 @@ static int ohci_hcd_at91_drv_remove(struct platform_device
*pdev)
int i;
if (pdata) {
- at91_for_each_port(i) {
- if (!gpio_is_valid(pdata->vbus_pin[i]))
- continue;
+ at91_for_each_port(i)
ohci_at91_usb_set_power(pdata, i, 0);
- gpio_free(pdata->vbus_pin[i]);
- }
-
- at91_for_each_port(i) {
- if (!gpio_is_valid(pdata->overcurrent_pin[i]))
- continue;
- free_irq(gpio_to_irq(pdata->overcurrent_pin[i]), pdev);
- gpio_free(pdata->overcurrent_pin[i]);
- }
}
device_init_wakeup(&pdev->dev, 0);
--
2.7.4
