Such debug lines might be useful when debugging the driver first,
but should be deleted from the upstream code.
Signed-off-by: Masahiro Yamada <yamada.masah...@socionext.com>
---
drivers/mtd/nand/denali.c | 12 ------------
1 file changed, 12 deletions(-)
diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
index 14e66ab..e32e13c 100644
--- a/drivers/mtd/nand/denali.c
+++ b/drivers/mtd/nand/denali.c
@@ -181,9 +181,6 @@ static uint16_t denali_nand_reset(struct denali_nand_info
*denali)
{
int i;
- dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
- __FILE__, __LINE__, __func__);
-
for (i = 0; i < denali->max_banks; i++)
iowrite32(INTR_STATUS__RST_COMP | INTR_STATUS__TIME_OUT,
denali->flash_reg + INTR_STATUS(i));
@@ -233,9 +230,6 @@ static void nand_onfi_timing_set(struct denali_nand_info
*denali,
uint16_t acc_clks;
uint16_t addr_2_data, re_2_we, re_2_re, we_2_re, cs_cnt;
- dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
- __FILE__, __LINE__, __func__);
-
en_lo = CEIL_DIV(Trp[mode], CLK_X);
en_hi = CEIL_DIV(Treh[mode], CLK_X);
#if ONFI_BLOOM_TIME
@@ -480,9 +474,6 @@ static uint16_t denali_nand_timing_set(struct
denali_nand_info *denali)
uint8_t maf_id, device_id;
int i;
- dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
- __FILE__, __LINE__, __func__);
-
/*
* Use read id method to get device ID and other params.
* For some NAND chips, controller can't report the correct
@@ -537,9 +528,6 @@ static uint16_t denali_nand_timing_set(struct
denali_nand_info *denali)
static void denali_set_intr_modes(struct denali_nand_info *denali,
uint16_t INT_ENABLE)
{
- dev_dbg(denali->dev, "%s, Line %d, Function: %s\n",
- __FILE__, __LINE__, __func__);
-
if (INT_ENABLE)
iowrite32(1, denali->flash_reg + GLOBAL_INT_ENABLE);
else
--
1.9.1
