On Thu 12 Oct 23:15 PDT 2017, [email protected] wrote: > From: Fenglin Wu <[email protected]> > > Get initial value of is_enabled flag by reading REG_EN_CTL register > so that it can reflect the correct hardware enable state before > setting pin config. > > Signed-off-by: Fenglin Wu <[email protected]> > --- > drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 9 +++++++-- > 1 file changed, 7 insertions(+), 2 deletions(-) > > diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c > b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c > index a0edaa8..0a1e173 100644 > --- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c > +++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c > @@ -106,6 +106,7 @@ > > /* PMIC_GPIO_REG_EN_CTL */ > #define PMIC_GPIO_REG_MASTER_EN_SHIFT 7 > +#define PMIC_GPIO_REG_MASTER_EN 0x80 > > #define PMIC_GPIO_PHYSICAL_OFFSET 1 > > @@ -914,8 +915,12 @@ static int pmic_gpio_populate(struct pmic_gpio_state > *state, > pad->atest = (val & PMIC_GPIO_LV_MV_ANA_MUX_SEL_MASK) + 1; > } > > - /* Pin could be disabled with PIN_CONFIG_BIAS_HIGH_IMPEDANCE */ > - pad->is_enabled = true; > + val = pmic_gpio_read(state, pad, PMIC_GPIO_REG_EN_CTL); > + if (val < 0) > + return val; > + > + pad->is_enabled = val & PMIC_GPIO_REG_MASTER_EN;
Please be more explicit here: is_enable = !!(val & ...) > + other than that, Acked-by: Bjorn Andersson <[email protected]> Regards, Bjorn
