On Mon, Aug 06, 2018 at 08:54:10PM +0200, Alexandre Belloni wrote:
> The Microsemi Ocelot I2C controller is a designware IP. It also has a
> second set of registers to allow tweaking SDA hold time and spike
> filtering.
> 
> Cc: Rob Herring <[email protected]>
> Reviewed-by: Andy Shevchenko <[email protected]>
> Signed-off-by: Alexandre Belloni <[email protected]>
> ---
>  .../bindings/i2c/i2c-designware.txt           |  9 ++++-

Please split binding patches.

>  drivers/i2c/busses/i2c-designware-core.h      |  3 ++
>  drivers/i2c/busses/i2c-designware-platdrv.c   | 40 +++++++++++++++++++
>  3 files changed, 50 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/i2c/i2c-designware.txt 
> b/Documentation/devicetree/bindings/i2c/i2c-designware.txt
> index fbb0a6d8b964..7886f2dc6675 100644
> --- a/Documentation/devicetree/bindings/i2c/i2c-designware.txt
> +++ b/Documentation/devicetree/bindings/i2c/i2c-designware.txt
> @@ -2,7 +2,8 @@
>  
>  Required properties :
>  
> - - compatible : should be "snps,designware-i2c"
> + - compatible : should be "snps,designware-i2c" or "mscc,ocelot-i2c" 
> followed by
> +   "snps,designware-i2c" for fallback

Please reformat to one valid combination per line.

>   - reg : Offset and length of the register set for the device
>   - interrupts : <IRQ> where IRQ is the interrupt number.
>  
> @@ -11,8 +12,12 @@ Recommended properties :
>   - clock-frequency : desired I2C bus clock frequency in Hz.
>  
>  Optional properties :
> + - reg : for "mscc,ocelot-i2c", a second register set to configure the SDA 
> hold
> +   time, named ICPU_CFG:TWI_DELAY in the datasheet.
> +
>   - i2c-sda-hold-time-ns : should contain the SDA hold time in nanoseconds.
> -   This option is only supported in hardware blocks version 1.11a or newer.
> +   This option is only supported in hardware blocks version 1.11a or newer 
> and
> +   on Microsemi SoCs ("mscc,ocelot-i2c" compatible).
>  
>   - i2c-scl-falling-time-ns : should contain the SCL falling time in 
> nanoseconds.
>     This value which is by default 300ns is used to compute the tLOW period.

Reply via email to