From: Thierry Reding <[email protected]> The IRQ core code refers to the interrupt type by that name, whereas the term flow is almost never used. Some GPIO controllers use the term flow_type, but it is most consistent to just go with the IRQ core terminology.
Signed-off-by: Thierry Reding <[email protected]> --- drivers/gpio/gpio-tegra186.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/gpio/gpio-tegra186.c b/drivers/gpio/gpio-tegra186.c index 9d0292c8a199..66ec38bb7954 100644 --- a/drivers/gpio/gpio-tegra186.c +++ b/drivers/gpio/gpio-tegra186.c @@ -279,7 +279,7 @@ static void tegra186_irq_unmask(struct irq_data *data) writel(value, base + TEGRA186_GPIO_ENABLE_CONFIG); } -static int tegra186_irq_set_type(struct irq_data *data, unsigned int flow) +static int tegra186_irq_set_type(struct irq_data *data, unsigned int type) { struct tegra_gpio *gpio = irq_data_get_irq_chip_data(data); void __iomem *base; @@ -293,7 +293,7 @@ static int tegra186_irq_set_type(struct irq_data *data, unsigned int flow) value &= ~TEGRA186_GPIO_ENABLE_CONFIG_TRIGGER_TYPE_MASK; value &= ~TEGRA186_GPIO_ENABLE_CONFIG_TRIGGER_LEVEL; - switch (flow & IRQ_TYPE_SENSE_MASK) { + switch (type & IRQ_TYPE_SENSE_MASK) { case IRQ_TYPE_NONE: break; @@ -325,7 +325,7 @@ static int tegra186_irq_set_type(struct irq_data *data, unsigned int flow) writel(value, base + TEGRA186_GPIO_ENABLE_CONFIG); - if ((flow & IRQ_TYPE_EDGE_BOTH) == 0) + if ((type & IRQ_TYPE_EDGE_BOTH) == 0) irq_set_handler_locked(data, handle_level_irq); else irq_set_handler_locked(data, handle_edge_irq); -- 2.19.0
