Defining card-detect and write-protect GPIO pins in Odroid XU SD Card
does not change anything from functional point of view - dw-mmc driver
was reading the state from registers. Adding cd-gpios and wp-gpios
properties changes only internal driver behavior to access the pins
directly.
Add them to DTS only to comprehensively describe the hardware. Minor
benefit is that write-protect pin configuration makes sure that it will
be properly pulled up to indicate write access.
This also removes debug messages:
dwmmc_exynos 12220000.mmc: No GPIO consumer cd found
dwmmc_exynos 12220000.mmc: No GPIO consumer wp found
Signed-off-by: Krzysztof Kozlowski <k...@kernel.org>
---
arch/arm/boot/dts/exynos5410-odroidxu.dts | 12 +++++++++++-
1 file changed, 11 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/exynos5410-odroidxu.dts
b/arch/arm/boot/dts/exynos5410-odroidxu.dts
index a2046f5f998c..dae360f29a47 100644
--- a/arch/arm/boot/dts/exynos5410-odroidxu.dts
+++ b/arch/arm/boot/dts/exynos5410-odroidxu.dts
@@ -525,12 +525,14 @@
&mmc_2 {
status = "okay";
+ wp-gpios = <&gpm5 0 GPIO_ACTIVE_LOW>;
+ cd-gpios = <&gpc2 2 GPIO_ACTIVE_LOW>;
card-detect-delay = <200>;
samsung,dw-mshc-ciu-div = <3>;
samsung,dw-mshc-sdr-timing = <0 4>;
samsung,dw-mshc-ddr-timing = <0 2>;
pinctrl-names = "default";
- pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_cd &sd2_bus1 &sd2_bus4>;
+ pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_cd &sd2_bus1 &sd2_bus4 &sd2_wp>;
bus-width = <4>;
cap-sd-highspeed;
vmmc-supply = <&ldo21_reg>;
@@ -573,6 +575,14 @@
samsung,pin-pud = <EXYNOS_PIN_PULL_NONE>;
samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV1>;
};
+
+ sd2_wp: sd2-wp {
+ samsung,pins = "gpm5-0";
+ samsung,pin-function = <EXYNOS_PIN_FUNC_2>;
+ /* Pin is floating so pull it up to disable write-protect */
+ samsung,pin-pud = <EXYNOS_PIN_PULL_UP>;
+ samsung,pin-drv = <EXYNOS5420_PIN_DRV_LV4>;
+ };
};
&pwm {
--
2.17.1
