The SDM845 has one Gen2 and one Gen3 controller, add support for these. Due to lack of hardware only the Gen2 controller has been verified.
Signed-off-by: Bjorn Andersson <[email protected]> --- .../devicetree/bindings/pci/qcom,pcie.txt | 19 +++ drivers/pci/controller/dwc/pcie-qcom.c | 146 ++++++++++++++++++ 2 files changed, 165 insertions(+) diff --git a/Documentation/devicetree/bindings/pci/qcom,pcie.txt b/Documentation/devicetree/bindings/pci/qcom,pcie.txt index 1fd703bd73e0..2cf92ed39499 100644 --- a/Documentation/devicetree/bindings/pci/qcom,pcie.txt +++ b/Documentation/devicetree/bindings/pci/qcom,pcie.txt @@ -10,6 +10,7 @@ - "qcom,pcie-msm8996" for msm8996 or apq8096 - "qcom,pcie-ipq4019" for ipq4019 - "qcom,pcie-ipq8074" for ipq8074 + - "qcom,pcie-sdm845" for sdm845 - reg: Usage: required @@ -116,6 +117,18 @@ - "ahb" AHB clock - "aux" Auxiliary clock +- clock-names: + Usage: required for sdm845 + Value type: <stringlist> + Definition: Should contain the following entries + - "aux" Auxiliary clock + - "cfg" Configuration clock + - "bus_master" Master AXI clock + - "bus_slave" Slave AXI clock + - "slave_q2a" Slave Q2A clock + - "tbu" PCIe TBU clock + - "pipe" PIPE clock + - resets: Usage: required Value type: <prop-encoded-array> @@ -167,6 +180,12 @@ - "ahb" AHB Reset - "axi_m_sticky" AXI Master Sticky reset +- reset-names: + Usage: required for sdm845 + Value type: <stringlist> + Definition: Should contain the following entries + - "pci" PCIe core reset + - power-domains: Usage: required for apq8084 and msm8996/apq8096 Value type: <prop-encoded-array> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c index d185ea5fe996..5147454a6ae5 100644 --- a/drivers/pci/controller/dwc/pcie-qcom.c +++ b/drivers/pci/controller/dwc/pcie-qcom.c @@ -54,6 +54,7 @@ #define PCIE20_PARF_LTSSM 0x1B0 #define PCIE20_PARF_SID_OFFSET 0x234 #define PCIE20_PARF_BDF_TRANSLATE_CFG 0x24C +#define PCIE20_PARF_DEVICE_TYPE 0x1000 #define PCIE20_ELBI_SYS_CTRL 0x04 #define PCIE20_ELBI_SYS_CTRL_LT_ENABLE BIT(0) @@ -80,6 +81,8 @@ #define PCIE20_v3_PARF_SLV_ADDR_SPACE_SIZE 0x358 #define SLV_ADDR_SPACE_SZ 0x10000000 +#define DEVICE_TYPE_RC 0x4 + #define QCOM_PCIE_2_1_0_MAX_SUPPLY 3 struct qcom_pcie_resources_2_1_0 { struct clk *iface_clk; @@ -139,12 +142,21 @@ struct qcom_pcie_resources_2_3_3 { struct reset_control *rst[7]; }; +struct qcom_pcie_resources_2_7_0 { + struct clk_bulk_data clks[6]; + struct regulator_bulk_data supplies[2]; + + struct reset_control *pci_reset; + struct clk *pipe_clk; +}; + union qcom_pcie_resources { struct qcom_pcie_resources_1_0_0 v1_0_0; struct qcom_pcie_resources_2_1_0 v2_1_0; struct qcom_pcie_resources_2_3_2 v2_3_2; struct qcom_pcie_resources_2_3_3 v2_3_3; struct qcom_pcie_resources_2_4_0 v2_4_0; + struct qcom_pcie_resources_2_7_0 v2_7_0; }; struct qcom_pcie; @@ -1076,6 +1088,129 @@ static int qcom_pcie_init_2_3_3(struct qcom_pcie *pcie) return ret; } +static int qcom_pcie_get_resources_2_7_0(struct qcom_pcie *pcie) +{ + struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0; + struct dw_pcie *pci = pcie->pci; + struct device *dev = pci->dev; + int ret; + + res->pci_reset = devm_reset_control_get_exclusive(dev, "pci"); + if (IS_ERR(res->pci_reset)) + return PTR_ERR(res->pci_reset); + + res->supplies[0].supply = "vdda"; + res->supplies[1].supply = "vddpe-3v3"; + ret = devm_regulator_bulk_get(dev, ARRAY_SIZE(res->supplies), + res->supplies); + if (ret) + return ret; + + res->clks[0].id = "aux"; + res->clks[1].id = "cfg"; + res->clks[2].id = "bus_master"; + res->clks[3].id = "bus_slave"; + res->clks[4].id = "slave_q2a"; + res->clks[5].id = "tbu"; + + ret = devm_clk_bulk_get(dev, ARRAY_SIZE(res->clks), res->clks); + if (ret < 0) + return ret; + + res->pipe_clk = devm_clk_get(dev, "pipe"); + return PTR_ERR_OR_ZERO(res->pipe_clk); +} + +static int qcom_pcie_init_2_7_0(struct qcom_pcie *pcie) +{ + struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0; + struct dw_pcie *pci = pcie->pci; + struct device *dev = pci->dev; + u32 val; + int ret; + + ret = regulator_bulk_enable(ARRAY_SIZE(res->supplies), res->supplies); + if (ret < 0) { + dev_err(dev, "cannot enable regulators\n"); + return ret; + } + + ret = clk_bulk_prepare_enable(ARRAY_SIZE(res->clks), res->clks); + if (ret < 0) + goto err_disable_regulators; + + ret = reset_control_assert(res->pci_reset); + if (ret) { + dev_err(dev, "cannot deassert pci reset\n"); + return ret; + } + + msleep(10); + + ret = reset_control_deassert(res->pci_reset); + if (ret) { + dev_err(dev, "cannot deassert pci reset\n"); + return ret; + } + + clk_prepare_enable(res->pipe_clk); + + /* configure PCIe to RC mode */ + writel(DEVICE_TYPE_RC, pcie->parf + PCIE20_PARF_DEVICE_TYPE); + + /* enable PCIe clocks and resets */ + val = readl(pcie->parf + PCIE20_PARF_PHY_CTRL); + val &= ~BIT(0); + writel(val, pcie->parf + PCIE20_PARF_PHY_CTRL); + + /* change DBI base address */ + writel(0, pcie->parf + PCIE20_PARF_DBI_BASE_ADDR); + + /* MAC PHY_POWERDOWN MUX DISABLE */ + val = readl(pcie->parf + PCIE20_PARF_SYS_CTRL); + val &= ~BIT(29); + writel(val, pcie->parf + PCIE20_PARF_SYS_CTRL); + + val = readl(pcie->parf + PCIE20_PARF_MHI_CLOCK_RESET_CTRL); + val |= BIT(4); + writel(val, pcie->parf + PCIE20_PARF_MHI_CLOCK_RESET_CTRL); + + if (IS_ENABLED(CONFIG_PCI_MSI)) { + val = readl(pcie->parf + PCIE20_PARF_AXI_MSTR_WR_ADDR_HALT); + val |= BIT(31); + writel(val, pcie->parf + PCIE20_PARF_AXI_MSTR_WR_ADDR_HALT); + } + + return 0; + +err_disable_regulators: + regulator_bulk_disable(ARRAY_SIZE(res->supplies), res->supplies); + + return ret; +} + +static void qcom_pcie_deinit_2_7_0(struct qcom_pcie *pcie) +{ + struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0; + + clk_bulk_disable_unprepare(ARRAY_SIZE(res->clks), res->clks); + regulator_bulk_disable(ARRAY_SIZE(res->supplies), res->supplies); +} + +static int qcom_pcie_post_init_2_7_0(struct qcom_pcie *pcie) +{ + struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0; + + return clk_prepare_enable(res->pipe_clk); +} + +static void qcom_pcie_post_deinit_2_7_0(struct qcom_pcie *pcie) +{ + struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0; + + clk_disable_unprepare(res->pipe_clk); +} + static int qcom_pcie_link_up(struct dw_pcie *pci) { u16 val = readw(pci->dbi_base + PCIE20_CAP + PCI_EXP_LNKSTA); @@ -1192,6 +1327,16 @@ static const struct qcom_pcie_ops ops_2_3_3 = { .ltssm_enable = qcom_pcie_2_3_2_ltssm_enable, }; +/* Qcom IP rev.: 2.7.0 Synopsys IP rev.: 4.30a */ +static const struct qcom_pcie_ops ops_2_7_0 = { + .get_resources = qcom_pcie_get_resources_2_7_0, + .init = qcom_pcie_init_2_7_0, + .deinit = qcom_pcie_deinit_2_7_0, + .ltssm_enable = qcom_pcie_2_3_2_ltssm_enable, + .post_init = qcom_pcie_post_init_2_7_0, + .post_deinit = qcom_pcie_post_deinit_2_7_0, +}; + static const struct dw_pcie_ops dw_pcie_ops = { .link_up = qcom_pcie_link_up, }; @@ -1306,6 +1451,7 @@ static const struct of_device_id qcom_pcie_match[] = { { .compatible = "qcom,pcie-msm8996", .data = &ops_2_3_2 }, { .compatible = "qcom,pcie-ipq8074", .data = &ops_2_3_3 }, { .compatible = "qcom,pcie-ipq4019", .data = &ops_2_4_0 }, + { .compatible = "qcom,pcie-sdm845", .data = &ops_2_7_0 }, { } }; -- 2.18.0
