Atish Patra <[email protected]> writes: > On 6/5/19 10:37 AM, Kevin Hilman wrote: >> Hi Paul, >> >> Paul Walmsley <[email protected]> writes: >> >>> Add support for building flattened DT files from DT source files under >>> arch/riscv/boot/dts. Follow existing kernel precedent from other SoC >>> architectures. Start our board support by adding initial support for >>> the SiFive FU540 SoC and the first development board that uses it, the >>> SiFive HiFive Unleashed A00. >>> >>> This third version of the patch set adds I2C data for the chip, >>> incorporates all remaining changes that riscv-pk was making >>> automatically, and addresses a comment from Rob Herring >>> <[email protected]>. >>> >>> Boot-tested on v5.2-rc1 on a HiFive Unleashed A00 board, using the >>> BBL and open-source FSBL, with modifications to pass in the DTB >>> file generated by these patches. >> >> Tested this series on top of v5.2-rc3 on HiFive Unleashed board using >> OpenSBI + mainline u-boot (master branch as of today). >> >> Tested-by: Kevin Hilman <[email protected]> >> >>> This patch series can be found, along with the PRCI patch set >>> and the DT macro prerequisite patch, at: >>> >>> https://github.com/sifive/riscv-linux/tree/dev/paulw/dts-v5.2-rc1 >> >> nit: I only see this series in that branch, not any of the prerequisite >> patches you mentioned, which made me assume I could this series alone on >> top of v5.2-rc3, which worked just fine. >> > > I tried only this series on top of v5.2-rc3. Kernel boots file with DT > updated via U-Boot. But networking didn't come up. > > Do you have networking up after the boot? If yes, can you please share > the config.
I didn't test networking from the kernel initially, but looking now, I do not have networking come up in the kernel either. Kevin
