On Mon, Jun 17, 2019 at 9:28 PM Andrew Lunn <and...@lunn.ch> wrote:
>
> On Mon, Jun 17, 2019 at 09:49:27AM +0530, Yash Shah wrote:
...
> > static const struct macb_config at91sam9260_config = {
> > .caps = MACB_CAPS_USRIO_HAS_CLKEN |
> > MACB_CAPS_USRIO_DEFAULT_IS_MII_GMII,
> > .clk_init = macb_clk_init,
> > @@ -3992,6 +4112,9 @@ static int at91ether_init(struct platform_device
> > *pdev)
> > { .compatible = "cdns,emac", .data = &emac_config },
> > { .compatible = "cdns,zynqmp-gem", .data = &zynqmp_config},
> > { .compatible = "cdns,zynq-gem", .data = &zynq_config },
> > +#ifdef CONFIG_MACB_SIFIVE_FU540
> > + { .compatible = "sifive,fu540-macb", .data = &fu540_c000_config },
> > +#endif
>
> This #ifdef should not be needed.
>
> > { /* sentinel */ }
> > };
> > MODULE_DEVICE_TABLE(of, macb_dt_ids);
> > @@ -4199,6 +4322,9 @@ static int macb_probe(struct platform_device *pdev)
> >
> > err_disable_clocks:
> > clk_disable_unprepare(tx_clk);
> > +#ifdef CONFIG_MACB_SIFIVE_FU540
> > + clk_unregister(tx_clk);
> > +#endif
>
> So long as tx_clk is NULL, you can call clk_unregister(). So please
> remove the #ifdef.
>
>
> > clk_disable_unprepare(hclk);
> > clk_disable_unprepare(pclk);
> > clk_disable_unprepare(rx_clk);
> > @@ -4233,6 +4359,9 @@ static int macb_remove(struct platform_device *pdev)
> > pm_runtime_dont_use_autosuspend(&pdev->dev);
> > if (!pm_runtime_suspended(&pdev->dev)) {
> > clk_disable_unprepare(bp->tx_clk);
> > +#ifdef CONFIG_MACB_SIFIVE_FU540
> > + clk_unregister(bp->tx_clk);
> > +#endif
>
> Same here.
>
> In general try to avoid #ifdef in C code.
Will remove all the #ifdef in v3.
Thanks for your comments.
- Yash
