On 19. 10. 8. 오후 8:52, Stephan Gerhold wrote:
> Commit f0b5c2c96370 ("phy: qcom-usb-hs: Replace the extcon API")
> switched from extcon_register_notifier() to the resource-managed
> API, i.e. devm_extcon_register_notifier().
>
> This is problematic in this case, because the extcon notifier
> is dynamically registered/unregistered whenever the PHY is powered
> on/off. The resource-managed API does not unregister the notifier
> until the driver is removed, so as soon as the PHY is power cycled,
> attempting to register the notifier again results in:
>
> double register detected
> WARNING: CPU: 1 PID: 182 at kernel/notifier.c:26
> notifier_chain_register+0x74/0xa0
> Call trace:
> ...
> extcon_register_notifier+0x74/0xb8
> devm_extcon_register_notifier+0x54/0xb8
> qcom_usb_hs_phy_power_on+0x1fc/0x208
> ...
>
> ... and USB stops working after plugging the cable out and in
> another time.
>
> The easiest way to fix this is to make a partial revert of
> commit f0b5c2c96370 ("phy: qcom-usb-hs: Replace the extcon API")
> and avoid using the resource-managed API in this case.
>
> Fixes: f0b5c2c96370 ("phy: qcom-usb-hs: Replace the extcon API")
> Signed-off-by: Stephan Gerhold <[email protected]>
> ---
> An other way to fix this would be keep the extcon notifier
> permanently registered, and check in qcom_usb_hs_phy_vbus_notifier
> if the PHY is currently powered on.
> ---
> drivers/phy/qualcomm/phy-qcom-usb-hs.c | 7 +++++--
> 1 file changed, 5 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-usb-hs.c
> b/drivers/phy/qualcomm/phy-qcom-usb-hs.c
> index b163b3a1558d..61054272a7c8 100644
> --- a/drivers/phy/qualcomm/phy-qcom-usb-hs.c
> +++ b/drivers/phy/qualcomm/phy-qcom-usb-hs.c
> @@ -158,8 +158,8 @@ static int qcom_usb_hs_phy_power_on(struct phy *phy)
> /* setup initial state */
> qcom_usb_hs_phy_vbus_notifier(&uphy->vbus_notify, state,
> uphy->vbus_edev);
> - ret = devm_extcon_register_notifier(&ulpi->dev, uphy->vbus_edev,
> - EXTCON_USB, &uphy->vbus_notify);
> + ret = extcon_register_notifier(uphy->vbus_edev, EXTCON_USB,
> + &uphy->vbus_notify);
> if (ret)
> goto err_ulpi;
> }
> @@ -180,6 +180,9 @@ static int qcom_usb_hs_phy_power_off(struct phy *phy)
> {
> struct qcom_usb_hs_phy *uphy = phy_get_drvdata(phy);
>
> + if (uphy->vbus_edev)
> + extcon_unregister_notifier(uphy->vbus_edev, EXTCON_USB,
> + &uphy->vbus_notify);
> regulator_disable(uphy->v3p3);
> regulator_disable(uphy->v1p8);
> clk_disable_unprepare(uphy->sleep_clk);
>
Reviewed-by: Chanwoo Choi <[email protected]>
--
Best Regards,
Chanwoo Choi
Samsung Electronics
