Hi Jonathan,
On 5/24/2020 5:29 PM, Jonathan Cameron wrote:
On Fri, 22 May 2020 19:54:10 +0530
Jishnu Prakash <[email protected]> wrote:
The ADC architecture on PMIC7 is changed as compared to PMIC5. The
major change from PMIC5 is that all SW communication to ADC goes through
PMK8350, which communicates with other PMICs through PBS when the ADC
on PMK8350 works in master mode. The SID register is used to identify the
PMICs with which the PBS needs to communicate. Add support for the same.
Signed-off-by: Jishnu Prakash <[email protected]>
---
drivers/iio/adc/qcom-spmi-adc5.c | 231 ++++++++++++++++++++++++++++++--
drivers/iio/adc/qcom-vadc-common.c | 260 +++++++++++++++++++++++++++++++++++++
drivers/iio/adc/qcom-vadc-common.h | 14 ++
3 files changed, 496 insertions(+), 9 deletions(-)
diff --git a/drivers/iio/adc/qcom-spmi-adc5.c b/drivers/iio/adc/qcom-spmi-adc5.c
index 21fdcde..e1482fd 100644
--- a/drivers/iio/adc/qcom-spmi-adc5.c
+++ b/drivers/iio/adc/qcom-spmi-adc5.c
@@ -1,6 +1,6 @@
// SPDX-License-Identifier: GPL-2.0
/*
- * Copyright (c) 2018, The Linux Foundation. All rights reserved.
+ * Copyright (c) 2018, 2020, The Linux Foundation. All rights reserved.
...
@@ -110,6 +120,7 @@ struct adc5_channel_prop {
enum adc5_cal_method cal_method;
enum adc5_cal_val cal_val;
unsigned int decimation;
+ unsigned int sid;
unsigned int prescale;
unsigned int hw_settle_time;
unsigned int avg_samples;
@@ -140,6 +151,7 @@ struct adc5_chip {
bool poll_eoc;
struct completion complete;
struct mutex lock;
+ int irq_eoc;
This is introduced but doesn't seem to be used...
I'll remove it in the next post.
const struct adc5_data *data;
};
@@ -155,6 +167,8 @@ static const struct vadc_prescale_ratio adc5_prescale_ratios[] = {
{.num = 1, .den = 16}
};
...
static int adc5_prescaling_from_dt(u32 num, u32 den)
{
unsigned int pre;
@@ -285,7 +304,7 @@ static int adc5_configure(struct adc5_chip *adc,
/* Read registers 0x42 through 0x46 */
ret = adc5_read(adc, ADC5_USR_DIG_PARAM, buf, sizeof(buf));
- if (ret < 0)
+ if (ret)
return ret;
As Andy mentioned, this is better in a separate patch. It's just adding
noise to this patch which is actually doing things...
I'll split it out into a separate patch in the next post.
/* Digital param selection */
@@ -314,6 +333,47 @@ static int adc5_configure(struct adc5_chip *adc,
return adc5_write(adc, ADC5_USR_DIG_PARAM, buf, sizeof(buf));
}
Thanks,
Jonathan
